4/27/2023 0 Comments Toshiba e studio 256Remedy: 1 Is the finisher working? Yes Replace the finisher controller PC board.Description: Receiving time time-out jam: The printing has been interrupted because of the communication error between the equipment and finisher when the paper is transported from the equipment to the finisher.Remedy: 1 Is the main motor rotating normally? Yes No 2 2 Replacing the PC board.Description: Print end command time-out jam: The printing has not finished normally because of the communication error between the SYS board and LGC board at the end of printing.Description: The detection of the home position of the folding blade motor ends abnormally.Board check Saddle stitcher controller board.Harness check Interface PC board (I/F).Harness check Ejecting roller sensor (S29).Harness check Transport path-3 sensor (S28). Harness check Transport path-2 sensor (S27).Harness check Junction box paper detection sensor (S26).Use paper accepted in the specifications.Check if there is any paper in the finisher, saddle stitcher or the on the transport path of the equipment.Causes: Feeding sensor (S22) Junction box paper detection sensor (S26) Transport path-2 (S27) Transport path-3 (S28) Ejecting roller (S29) Interface PC board (I/F) Saddle stitcher controller board Finisher controller board.Description: Short paper jam: Short paper jam (Saddle Stitch Finisher).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |